Filter Systems

Pre-Filter

A pre-filter that is plumbed in before the Bill Miller and Family water softener and/or iron filter helps to protect the systems from damage that your well might be producing.  This standard pre-filter housing is manufactured of reinforced polypropylene.  The leak proof seal is accomplished by the cap compression against the top seated O-Ring in the sump.  The thread closure allows for years of cartridge change outs without failure.  The thick walls and multiple rib design make these pre-filter housings ideal for any application.  The clean look and light weight also makes them preferred in residential and commercial uses.  The pre-filter polypropylene construction has excellent chemical resistance for use with most acids, alcohols, ammonias, oils, plating solutions, beverages and water.  This unit has a pressure relief bleed button on the inlet side of the cap.  The pressure relief mechanism is constructed of a stainless steel spring and screw, gasket and polypropylene red button. NOTE: Actual maximum flow rates vs. pressure drop will be determined based on the cartridge selections and fluid viscosity.  We recommend the S-1 paper accordion filter. *  Each installed pre-filter comes with two ball valves for easy changing of the pre-filter, plus one wrench and two S-1 paper accordion filters.

Whole House Filters

A “whole house filter” is plumbed in after

the Bill Miller and Family water softener conditioning system.  The “whole house filter” is like having a Reverse Osmosis (R/O) system but it gives you great tasting drinking water to “EVERY” faucet in the house, not just one or two.  There is no water run off or constant drip to a drain with our whole house filter.  

This whole house filter housing is manufactured of reinforced polypropylene. 
The thread closure allows for years of cartridge change outs without
failure.  The thick walls and multiple rib design makes the whole house filter ideal for this application.  The clean look makes them preferred in residential
and commercial uses.  This unit has a pressure relief bleed button on the inlet side of the cap.  The pressure relief mechanism is constructed
of a stainless steel spring and screw, gasket and polypropylene red button.

NOTE: 
We use a high tech carbon filter so it only needs to be changed once a
year.  We will call you each year and change the filter for you so you don’t have to worry about it.  We only charge you for the cost of the filter and not a service fee on top of that.

* Each installed whole house filter comes with one ball valve for easy changing of the whole house filter, plus the high tech carbon filter.